- Manuals
- Brands
- Zoo Fans Manuals
- Fan
- H25
- Installation manual
Hide thumbs Also See for H25:
- Operating manual (6 pages)
-
- Contents
- Table of Contents
- Bookmarks
Table of Contents
-
Important Safety Information
-
Table of Contents
-
Pre-Installation
-
Parts Enclosed
-
Zoo Fans Specifications
-
Layout
-
Installation
-
Hanging the Fan
-
STEP 1: Fasten Main Hanging Cable
-
STEP 2: Fasten Stabilization Tether
-
STEP 3: Secure the Gripples
-
-
WIRING the FAN (Optional)
-
Advertisem*nt
Quick Links
- 1 Zoo Fans Specifications
- 2 Wiring the Fan (Optional)
- Download this manual
See also: Operating Manual
Installation Guide
Models: H25 / H30 / H60
Covered by the following United States and International Patents:
D631148S, 138172, 001790452-001, 338608 and other patents pending
ZOO Fans is a Trade Mark of Zoo Fans Incorporated
1650 38
th
St, Suite 201W
Boulder, CO 80301
(303) 557-1852
zoofans.com
©2017 ZOO FANS INC. ALL RIGHTS RESERVED
REV 10042017
Table ofContents
Advertisem*nt
Table of Contents
Related Manuals for Zoo Fans H25
-
Fan Zoo Fans H25 Operating Manual
Open-ceiling models (6 pages)
-
Fan Zoo Fans H30 Installation Manual
(14 pages)
-
Fan Zoo Fans H30 Operating Manual
(8 pages)
-
Fan Zoo Fans H25-EC Installation Manual
(16 pages)
-
Fan Zoo Fans H60-EC Installation Manual
(16 pages)
-
Fan Zoo Fans IC20 Drop-In Installation Manuals
(16 pages)
-
Fan Zoo Fans IC15-MF Installation Manual
(20 pages)
-
Fan Zoo Fans IC20-AC Operating Manual
(7 pages)
Summary of Contents for Zoo Fans H25
- Page 1 Models: H25 / H30 / H60 Covered by the following United States and International Patents: D631148S, 138172, 001790452-001, 338608 and other patents pending ZOO Fans is a Trade Mark of Zoo Fans Incorporated 1650 38 St, Suite 201W Boulder, CO 80301 (303) 557-1852 zoofans.com...
- Page 2 AVERTISsem*nT : Restez vigilent, faites attention à ce que vous faites, et faites preuve de bon sens lors de l’installation de ventilateurs ZOO Fans. N’installez pas de ventilateurs si vous êtes fatigué ou sous l’influence de drogues, d’alcool ou de médicaments.
-
Page 3: Important Safety Information
WARNING: To prevent electrical shock and/or injury disconnect fan from power source before you move or service the fan. Suitable for use with solid-state speed controls. WARNING: To reduce the risk of fire, electric shock, and injury to persons, ZOO Fans must be installed only with controllers supplied by ZOO Fans. Other parts cannot be substituted. -
Page 4: Table Of Contents
STEP 2: Fasten Stabilization Tether ............................4 STEP 3: Secure the Gripples ..............................5 WIRING THE FAN (Optional) ..............................7 1650 38 St, Suite 201W Boulder, CO 80301 PHONE: 303-557-1852 zoofans.com ©2017 ZOO FANS INC. ALL RIGHTS RESERVED REV 10042017... -
Page 5: Pre-Installation
PRE-INSTALLATION The safe installation and operation of equipment supplied by ZOO Fans is the responsibility of the system designer, installer, maintainer, and operator (collectively, the “User”). The need for protective safety accessories to meet company standards, applicable codes, and the requirements of the Occupational Safety and Health Act (“OSHA”) must be determined by the User since safety requirements may vary depending on the location and application of the equipment. -
Page 6: Zoo Fans Specifications
You may also contact your ZOO Fans’ representative or ZOO Fans directly if you require assistance. Remember, the number of ZOO Fans required for the job, as well as where they are hung, will depend on a number of variables, some of which are: •... -
Page 7: Installation
The fan intake must be 12” from any obstruction. ZOO Fans are designed to be hung vertically or at an angle. For vertical installations, proceed to STEP 1 below. To install the ZOO Fan at an angle, additional hardware is required. Please contact ZOO Fans or your ZOO Fans’... -
Page 8: Step 2: Fasten Stabilization Tether
2. Insert 1/4” Hex Head bolt through the hole located at 45° on either side of the handle 3. Securely tighten 1/4” Nylock Nut Illustration 2 1650 38 St, Suite 201W Boulder, CO 80301 PHONE: 303-557-1852 zoofans.com ©2017 ZOO FANS INC. ALL RIGHTS RESERVED REV 10042017... -
Page 9: Step 3: Secure The Gripples
2. Loop cable over Truss, I-Beam, or support beam 3. Insert end of cable into Gripple 4. Adjust to desired height Illustration 3 1650 38 St, Suite 201W Boulder, CO 80301 PHONE: 303-557-1852 zoofans.com ©2017 ZOO FANS INC. ALL RIGHTS RESERVED REV 10042017... - Page 10 4. Adjust cable so there is no slack 5. Excess cable should be neatly rolled up and taped or cut for a clean installation Illustration 4 1650 38 St, Suite 201W Boulder, CO 80301 PHONE: 303-557-1852 zoofans.com ©2017 ZOO FANS INC. ALL RIGHTS RESERVED REV 10042017...
-
Page 11: Wiring The Fan (Optional)
All safety features (surge suppression diode AND motor run capacitor) must remain installed CAUTION: For use with manufacturer supplied controller. Not for use with other speed control devices! Illustration 5 1650 38 St, Suite 201W Boulder, CO 80301 PHONE: 303-557-1852 zoofans.com ©2017 ZOO FANS INC. ALL RIGHTS RESERVED REV 10042017... - Page 12 1650 38 St., Suite 201W Boulder, CO 80301 Phone: (303) 557-1852 Fax: (720) 596-5192 info@zoofans.com zoofans.com 1650 38 St, Suite 201W Boulder, CO 80301 PHONE: 303-557-1852 zoofans.com ©2017 ZOO FANS INC. ALL RIGHTS RESERVED REV 10042017...
This manual is also suitable for:
H60H30
